OblinEngine has progressed through modelling, prototype construction, shallow hydraulic testing and deep-shaft testing. The technology is currently at TRL 5, with the next development stage being an integrated Australian demonstrator intended to progress the technology to TRL 6.
The development program has been staged to generate physical evidence, reduce technical uncertainty and progressively move the technology through successive readiness levels.
Initial modelling and system design established the proposed relationship between compressed-air injection, hydraulic uplift and recoverable water flow.
Controlled prototype testing measured air input, water movement and hydraulic head under shallow experimental conditions.
Testing at approximately 92.5 metres provided evidence that the hydraulic uplift mechanism remained effective at substantially greater depth.
The next stage is an integrated Australian demonstration intended to generate system-level evidence required for progression from TRL 5 to TRL 6.
The existing development position is supported by completed physical testing of the core hydraulic uplift mechanism.
The proposed Australian demonstrator will integrate the major system components and measure performance across the full energy pathway.
The existing TRL 5 position is based on completed physical testing, not solely on modelling or theoretical analysis.
Early physical testing examined whether controlled compressed-air injection could generate measurable water uplift and hydraulic head.
The tests investigated the relationship between injected air, water flow, bubble behaviour and resulting hydraulic head under controlled conditions.
One measured result from the shallow program was an approximate water-to-air flow relationship of 8.36:1 at approximately 175 mm hydraulic head.
Demonstrate the underlying mechanism, establish measurement methods and generate evidence to support progression to deeper testing.
Illustrative two-phase air-water flow image. It is not presented as a photograph of the measured shallow test.
The next major development step was deep-shaft testing at approximately 92.5 metres.
The purpose was to determine whether the hydraulic uplift mechanism remained observable under materially greater water-column depth and injection pressure.
Approximately 2.4 metres of hydraulic head was demonstrated during the deep test.
This testing provided further physical evidence supporting the current TRL 5 position and progression toward an integrated TRL 6 demonstrator.
Conceptual shaft visualisation, not a photograph of the completed 92.5 m test installation.
The TRL 6 project must move beyond subsystem evidence and demonstrate the integrated system under representative operating conditions.
Operate the compressor, air-delivery system, uplift shaft, hydraulic circuit and turbine-generator as one integrated system.
Measure electrical input, electrical output and auxiliary consumption across defined operating conditions.
Measure air flow, pressure, water flow and hydraulic head throughout representative test runs.
Determine whether observed system performance can be reproduced across multiple operating cycles and defined conditions.
Characterise operating behaviour, system stability and the control requirements of the integrated demonstrator.
Generate evidence suitable for external technical review of whether progression from TRL 5 to TRL 6 is justified.
The proposed demonstrator is intended to measure the major electrical, pneumatic and hydraulic variables needed to assess system performance.
Where the final test configuration provides a valid complete charge-discharge measurement boundary, the project is also intended to determine round-trip efficiency.
OblinEngine is not represented as already being at TRL 6.
Independent technical assessment is intended to examine the demonstrator methodology, instrumentation, recorded data, repeatability and resulting performance evidence.
The purpose is to determine whether the integrated results support progression from the existing TRL 5 position to TRL 6.
The development program distinguishes clearly between what has already been demonstrated at TRL 5 and what remains to be demonstrated at TRL 6.
The proposed Australian integrated demonstrator is intended to generate the measured system-level evidence required to progress OblinEngine from TRL 5 to TRL 6.